Welcome to Norfolk, Virginia, USA

Friday June 27 — As we’d learned the hard way, we needed to leave at a higher tide or else we’d be grounded. We untied at 0550. The day was grey and overcast, and the sun was not visible behind the cloud cover. At first, the sea conditions were surprisingly uncomfortable, with sea spray regularly coming over the bow. It calmed down within an hour or so, though.

For the majority of the trip, we had 2-foot swells and 3-foot wind chop and light wind. There was a fair amount of traffic, and all kinds of boats, including sailboats, trawlers, tiny fishing boats, etc. There were several small craft that AIS identified as “MC experimental” that appeared to be military vessels doing circles. There was a small ship that particularly caught our attention. AIS identified as “High Speed Vessel” that looked like a small research vessel. Later, we found out it was a service vessel for a near-by off-shore wind farm.

Crossing the shipping lane was a little scary. At different points in time, we were on a collision course with 2 different vessels, so we needed to alter course each time to avoid them.

It was hot and humid outside, so Eric ran the generator and the salon and downstairs A/C units the entire 7.5-hour trip.

Continue reading

More Exploring Deltaville, Virginia, USA

Dawn on Wednesday

On the passage, Eric had noticed an issue with the newly fixed radio: it was working fine, but it was complaining about low voltage. He spent Wednesday morning on the phone with the company who’d done the repair to troubleshoot the problem. Eric eventually figured out that there was a knob to adjust voltage on the power supply unit (which was behind the panel), and that knob was in a spot where it could have been easily bumped when the converter box was installed. In the course of the troubleshooting, the “expert” gave Eric some incorrect information, which really bothered Eric.

In between phone calls, Eric changed the generator oil and filter, drained the engine oil, and replaced the O ring in the oil drain hose for the main engine. We also went to the boat yard next door to say goodbye to the family that had been hauled out yesterday. They were a really nice family and we hope to see them again when they return.

Continue reading

The Beginning of the Passage From North Palm Beach, FL to Deltaville, VA

On Thursday, June 19, 2025, we spent the morning getting ready to go to sea. Johnny came to Kosmos to say goodbye and pick up his car. We untied at about noon and headed south.

Given that it was a Thursday, the ICW was surprisingly busy, especially around Peanut Island, and the ride was a bit rocky from all the wakes. The current was about 1.5 knots against us, which made the autopilot sometimes struggle to stay on course. Making the trek through the ICW a little stressful in the tight quarters.

Continue reading

Finishing Up the Boat Work and Getting Fuel in North Palm Beach, Florida, USA

On Tuesday, June 17, we missed the sunrise, but here was a morning shot.

We spent Tuesday and Wednesday finishing up the projects. Eric confirmed radios were working, the other two air conditioning units were descaled, and Yacht Tech finished up the waxing, stainless polishing, and the gelcoat work. Unfortunately, not every gelcoat spot was repaired. There had been two separate work orders, and due to a misunderstanding, Eric had only authorized one.

We’d mentioned that the bottom red boot stripe had been touched up. Yacht Tech also touched up the smokestack stripe. When all the outside work was completed, they gave Kosmos a good washing and wipe down.

Continue reading

More Boat Work, North Palm Beach, Florida, USA

Dawn in Punta Gorda on Monday, June 16.

First thing in the morning, we said our goodbyes to Christy and headed back to Kosmos in North Palm Beach. This time, we took the Highway 70 back, which, for most of the drive was a two lane highway. The road took us through several small towns and a lot of farmland. It was a nice drive, with a lot more character and local feel that we’d gotten from I-75.

When we arrived, there were already workers onboard. On the exterior, there were people detailing the boat, one finishing up the waxing and one polishing the stainless steel.

Inside, someone was working on the VHF radios. We’d upgraded the radios in 2024, but there was a buzzing when the battery chargers were going, which interfered with our ability to hear/be heard. DC to DC voltage converters were installed.

Continue reading